1998 Oldsmobile Intrique Transmission Connector View

I have a 1998 Oldsmobile intrigue 3.8l and the transmission has a trouble code P0742 - torque converter clutch solenoid stuck on. I need to either replace the solenoid or clip the wire on the connector that has the control signal to the solenoid. I decided to replace the solenoid, which requires dropping the thing out of the car, so I started taking it apart. One of the bolts holding the it to the engine is impossible to reach without pulling the entire engine out of the car.

I have been trying to reach that bolt for a month and a half. I have bought every tool known to man, and the bolt is just not reachable, without pulling the engine, and pulling the exhaust manifold. I bought an Alldata subscription, and the bolt is bolt #6 in the procedure, and it just says "take it out" like it is no problem, it is the lower transmission bolt on the rear facing side, and all the other bolts go through the transmission, and thread into the engine. This one goes from the engine side and threads into it I contacted Alldata tech support, and they just gave me my money back instead of dealing with a procedure that wont work as far as I am concerned because the bolt is impossible to reach.

I have worked on cars all my life, done everything, I am not some idiot working over my head. I am at my wits end. I will pay money for anybody that can tell me how to remove that bolt without pulling the engine, or can tell me the wire to clip on the connector to disable that solenoid, and I will drive it without the torque converter clutch and I know it will reduce my gas mileage, but at least the car will be usable.

I assume you have code P0742.
OK. Well, first off, to get that bolt, the support bracket on the final drive end (rt. side) of the transmission needs to come off after popping out the axle. It is the bracket that bolts the end of the transmission to the engine- from the right wheel well. Then use a long extension through the wheel well, with a universal socket. You will not be able to see the bolt to good, so have to kind of move the extension around until you get the socket to and on the bolt.

2 nd.- See image below. You do not need to remove the whole unit to replace the TCC solenoid. You can get it by removing the left side cover. This involves lowering the entire transmission / engine assembly on the left side. This involves removing the mounts, large bracket, control arm, axle, control arm, left frame bolts, and then lowering the entire assembly out of the car far enough to get the cover off. The entire assembly must have support fixtures on top.

3rd.- A wire to cut at the connector would be the BROWN wire, terminal "T".

Tranmsision connector

Oldsmobile Intrigue Transmission connector end view.

Please login to comment

   ---Subscribe To Your Comment   

  • No comments yet.